top of page

How to Apply and Remove a Face Camera Cover

6 days ago
1 min read

A face camera cover takes about ten seconds to put on. Here’s how to get a clean, bubble-free fit every time.


Application instruction step

Before you start

Wipe the area around the camera with a dry microfiber cloth to remove dust and fingerprints. A clean surface helps the adhesive hold.


Step by step


  1. Peel one cover from the sheet. Each 3y3patch kit comes on a 3-by-5-inch sheet of 35 individual covers.

  2. Line the cover up over the camera lens only. Many devices have a light sensor or indicator light next to the lens, so check your device before pressing down.

  3. Press from the center outward to push out air bubbles.

  4. Press the edges down firmly so the cover sits flat.


Using your camera again


The adhesive is clear and low-tack, so a cover peels away cleanly when you need the camera. 3y3patch covers are removable and reusable, so you can lift one for a call and put it back afterward.


A note for phones with face unlock


If your phone unlocks with your face, covering the camera area can stop face unlock from working until you remove the cover. Try the cover on a test device or check your phone’s sensor layout first.


Why thin matters on laptops


Laptop screens sit very close to the lid’s edge when closed, so a thick cover can press against the display. At 0.08mm, 3y3patch covers are designed to stay out of the way.


More questions? Visit the FAQ or shop covers.

 
 
 

Comments


bottom of page